Provides on-site supervision of the Logging- While-Drilling (LWD) and Measurements While Drilling (MWD) process, including tool preparations, data acquisition, log generation and Quality Control (QC) and delivery of the services to the customer. Properly tests and measures all tools and equipment before Run in Hole (RIH), during and after each job. Identifies and corrects operational problems to prevent or minimize service impact. Accurately completes all required forms, databases and reports (i.e. Work permit , lost/damaged equipment, radiation site survey, End of Well Report (EOWR), DMAG for the Final Surveys in case if it’s out of Field Acceptance criteria (FAC). Ensures BHA's are assembled as planned, including correct make-up torque, doping and handling. Aware of customer requirements regarding directional survey procedures. Interfaces with the Directional Driller (DD) to ensure BHA compatibility and tool face correction is applied (TFC). Planned operating parameters are within specification. Participates in performance improvement initiatives as required. Ensures all equipment, personnel and resources needed to perform the service is available. Proficient in the use of M/LWD software and able to provide advice and analysis to the client representative at the well site. This include survey calculations, log generation, basic geosteering services and data quality control (QC). Ensures a daily M/LWD report is completed and copied to client's onsite and offsite drilling teams and to the M/LWD coordinator. Responsible for submitting an accurate daily cost for the M/LWD services. Assists in the evaluation of individual performance levels of onsite M/LWD personnel. Assists in the training and development of junior personnel. Foster teamwork among all personnel involved in the performance of the work.