Arul Murugan.B

• Preparation of Post Tensioned drafting and detailing.
• Preparation of reinforcement detailing drawings and bar bending schedules using CADS RC.
• Preparation of General arrangement and RCC detailing drawings of Foundations, Columns, Beams and Slabs

• Modeling for Integrated Environmental Solution (IES).

• Preparation of P&ID as per client Requirement in Auto-Cad.
• Preparation of general arrangement drawings and piping isometrics from P&ID and equipment layout.
• Development of equipment layout using P&ID.
• Modeling the Equipments from Vendor detail documents.
• Pipe spans calculations and selection of supports.
• Pipe wall thickness calculation.
• Piping material specification and valve data sheet.
• Preparation of MTO’S.
• Selecting the sizes and materials based on ASME, ASTM Standards.
• Familiar with ASME B 31.3andASme 31.1, IS codes & ASME codes related to Process & power piping.

Role in PDMS

• Modeling the Equipments & Instruments from Vendor detail documents.
• Modeling the pipe routing with respect to Corresponding P&ID and Piping Spec..
• Preparing final General Arrangement Drawings and Equipment location drawing.
• Modeling the interconnecting pipe routing from IPD layout.
• Clash Checking for pipe routing.
• Locating the pipe supports with stress engineer support
• Data consistency checking for Pipe routing.
• Extraction of Isometric drawings to dxf from PDMS.

• • Check and Prepare the Proposal and Contracts P&ID from the Tender Documents
  • Preparation of  Piping layout for integral, external and critical piping with required instruments by using P & I diagram, considering the fouling with structures, members and other equipments
  • Detailing of IBR & Non-IBR piping
  • Checking Composite layout for piping system.
  • Clarification of issue which are from the shop and site.
  • Hanger & support arrangements based on Layout and isometric drawings, stress analysis reports, platform and Structural drawings.
  • Power piping (integral, external piping & critical) fabrication drawings checking
  • Selection of spring hangers for supports.
  • Codes and standards for “Fittings, Valves, Vessels, Tanks, piping

   

• General Arrangement of Boiler Sectional Plan, Side Elevation & Front Elevation.

• Key plan of boilers, ID system.
• Ducting Arrangements. (Hot air, Cold air & Flue gas.)
• Floor Plan Drawings of Boiler.
• Vertical bracings, Location of Furnace Openings and Buck Stays.

Mechanical Engineering