process engineer

*process design *LTD line designation table, *pump heat sheet, *P&ID review *line size, *vessel size, *check form update, *scope of work, *start up activities, *pre-commissioning, commissioning activities, *simulation aspen hysys *vessel size guide update, *CCR tech. research , *solve the problem with operation team at Alexandria petroleum company , Nassr petroleum company ,EL Suez petroleum company *process engineer with the start up team at E-STYRENICS *process leader at ANRPC company for commissioning and start up phase *Attend FAT test for new land oil project (petropell comapny) *Attend hazop for ABO ELGRADEAA company for new compressor tie in *Attend hazop review meeting for poly ethylene project(ETHYDCO company) *Attend 3D model review meeting for poly ethylene project. *Attend start up for phase 7 for gas project(RASHPETCO) *one of team prepare the operation manual for petrochemical project. *working on my master about(low temperature separation technology for gas) *make a diploma at MBA(Nottinghill university) *working on my diploma at human resource.(recruitment and selection / training and development) *finished my pre-master with very good grade. * QMS (quality management system) leader for poly ethylene project. *prepare training course for new comers. *Attend welding test. *review logic description *proposal of new tie in at KNPC company *presentation about the gas activities at Tanzania. *now attend the construction phase for polyethylene project . *prepare case and effect paper. *review the graphic display for control room. *review logic-description for polyethylene project. *prepare project report for site activities